The T2 Arthrodesis Nailing System provides a solution for the treatment of knee arthrodesis.

Various locking modes provide options for stable fixation:

• Four locking holes are strategically placed within 32 mm to the driving end to enable three plane fixation in the distal femur.
• The most distal hole is centered at 6 mm from the driving end of the nail.
• Cannulated implants allow reamed or unreamed insertion over a 3 x 1000 mm guide wire.
• No guide wire exchange required after reaming.
• Advanced locking for increased rotational stability.
• 4° bend and R 2.0 antecurvature for the long nails adapt to the femoral anatomy.
• All locking screws for short nails (170 and 200 mm) can be inserted via targeting device.
• 5.0 mm cannulated condyle bolts with pre-attached and adjustable washers allow insertion over k-wires and provide up to 7 mm of mediolateral interfragmentary compression.
• Proximal oblong hole allows dynamization.
• Dedicated End Cap tightens down on most distal locking screw or condyle bolt to provide the additional stability and prevent bony ingrowth into the driving end to facilitate nail removal.

Based on the common instrumentation platform (same instrumentation as T2 Femur), all cannulated 11.5 & 13 mm nails use 5.0 mm locking screws and do not require guide wire exchange after reaming.

The sophisticated design features a curvature which incorporates both femur antecurvature and knee valgus bend and is available in left and right, providing a “best fit” for each patient´s individual indication.